Superflex granulated in colours flexible wall coat. Denber Paints

Superflex granulated in colours flexible wall coat

Highly flexible acrylic coat advanced sealing system

Flexible thick decorative isolation coat for interior and exterior use. Acrylic high build coat with elongation for bridging over cracks up to 2 mm. and filling capillary cracks. Isolates from rain penetration in the winter and reduce heat of the sun in the summer.

Produced according the Israel Institute of standards 1731 for bridging over 2 mm cracks.

Superflex granulated in colours flexible wall coat. www.denber-paints.co.il

Properties:

Very flexible, expands up to 4 times (400% elongation)
Pure acryl, UV durable, for long lasting under direct sun. suitable for exterior use.
High build.
“Breathing” allows humidity to transfer out and seals from water penetrate in.
Prevent condensation.
Flexible & decorative coat, bridging capillary cracks.
Solvent less and can be apply in close rooms with low
Easy to apply by spreading with roller or brush and also spraying. White color – on exterior walls – reflects 75% of sun light and reduce the heating of the walls..
Good adhesion to metal and concrete walls and surfaces.
Washable and scrubbing resist. Exterior weather
Fast drying – ready for recoat every 4-6 hour according temp.

Superflex granulated in colours flexible wall coat

Highly flexible acrylic coat advanced sealing system

Application:

For painting outdoor walls for decoration, sealing, heat reducing and cracks bridging,
For coating exterior concrete walls, mortar, asbestos, breaks, gypsum etc.
For isolating hot walls or elements near stoves or heat emitting instruments.
For coating corrugated and asbestos roofs and walls for heat isolation from the sun and sealing from rain.
For renovation walls of old buildings.
For coating problematic walls tend to crack,

Technical Data:

Theoretical spreading rate: 1 liter per 4-5
Practical thickness for crack bridging of 2 mm: 1-5 kg per sqm.
Flexibility: 1 mm (sheen).
Density: 2-1.3 gm\cm³
Viscosity: 100,000 cPs (Briikfield)
Hardness: >3 Dg (Erichsen).
Stretching strength: 30 kg\cm²
Average adherence strength: 72 MPa.sec.
Elongation: 400%
Average bridging ability before erosion: 2 mm.
Average bridging ability after erosion: 78 mm.
Elongation of 5 years old film: 280%
Recommended number of layers by spraying: 3-4
Recommended number of layers by roller: 6-8 150-250 micron wet per layer.
Recommended thickness by spraying: 350-450 microns wet.
Solids: 67%
Erosion: 120 mic. film – 760 cycles (BYK Gardener)
Wash ability: 1000 cycles with no paint peeling Israel standard 1945
Scrubbing resistance: 200 cycles Israel standard 1945

Superflex granulated in colours flexible wall coat

Highly flexible acrylic coat advanced sealing system

Contains:

Acrylic flexible emulsion.
Flexibility advanced materials.
Pigments and fillers.
Fungicides, conservation materials.
UV rejection
Wetting and self leveling
Thixotropic additives.

Colors:

Standard shades according Denbercryl catalog shades and 1000 shades catalog.

Gloss:

Matte

Touch – drying time:

1 hour.

Repainting Gap Time:

6-24 hours, according to Final – 24 hours.

Recommended Application Methods:

Roller,
Spray – with spray gun with top paint container and nozzle 2 for flat smooth coat and nozzle 3” for orange effect.
It is forbidden to apply in rainy
Roller – dilution with water 20% for smooth surface. No dilution for orange effect.

Superflex granulated in colours flexible wall coat

Highly flexible acrylic coat advanced sealing system

Instruction for dilution and use for bridging over 2 mm cracks:

Open carefully and stir
Primer coat – Denbertex primer (solvent dilution) 250 gram per 1 sqm. or if solvents orbited Denberoll Super water base.
First coat – 300 micron dry Superflex wall diluted 20-30% with water.
Second and third – for cracked wall: more 500-700 micron dry minimum in two coats or 3 without leaks

Dilution:

For spraying and roller : 20-30%
Airless : 5-10%
With no dilution a fine orange effect will appear.

Surface Preparation:

Surface must be clean from dirt, rust, oils and previous
External walls – water pressure clean 150 atm.remove lose paint.
Filling cracks with denberschpachtel acrylic and sand for smooth surface.
Primer layer according the surface- Denbertex primer for concrete walls or painted panels.
Construction cracks over 3 mm. open and clean and fill with Polyflex mastic a one component PU crack filler.

Primer:

For concrete and metal painted sheets panel – Denbertex primer or Denbeoll super +2 coats Denbercryl 3000
For bitumen roofs – aqua flex or Epoxyden primer water base.

Package:

5 liter, 18 liter.

Superflex granulated in colours flexible wall coat

Highly flexible acrylic coat advanced sealing system

Storage:

Appropriate shaded room with proper ventilation
Keep lids hermetic sealed.

Shelf Life:

12 month in original pack.

Clean Up:

Clean with water and soap after painting completion

Quality control:

In factory laboratories according to specifications.
COA and COC certificate.
ISO 9001-20115

Safety precautions:

Inedible, keep away from the reach of children.
While applying, good air ventilation is important. In case there is not enough air, use ventilation according to the ventilation table.
Wear protective glasses, gloves and suits.
Avoid direct contact of the paint and/or thinner with the eyes and skin. In case of contact, immediately wash thoroughly with water.
In case of an injury immediately get doctors assistance.
Read the safety instructions on the labels.
See M.S.D.S

Superflex granulated in colours flexible wall coat