Diversity solution for crystalline epoxy

Hard drying – 24 hours

Can be applied by casting into a mold.

 Instructions for use:  Add the diversity solution to part A to obtain the desired shade and the desired transparency. Mix part A well to obtain a uniform shade. Pour from Part A the desired amount for pouring into a new and clean vessel. Consider the amount of material you have poured. Add  exactly  50% by weight. Mix immediately and quickly and pour into another new, clean vessel. Mix lightly and pour immediately before the material heats up. Material that has been heated before casting may crack. This should be avoided.

Ensure adequate ventilation during application.

Wear goggles, gloves, protective clothing.

In case of injury – seek medical attention immediately.

Be sure to carefully read the safety instructions on the label before starting work with the product .

Note:

The diversity solution is 100% crystalline epoxy, when it is added to part A it becomes an integral part of it. Weigh part A mixed with the solution and add exactly 50% by weight

Excess or lack of hardness will harm the quality of the finished product.

Contains: 1 liter

• Do not mix with materials not recommended by us. and
• Avoid contact with skin and eyes, causes dryness and skin irritation. In case of contact, wash with plenty of running water and seek medical attention. and

Solutions in many shades to diversify crystalline epoxy for inclusion in part A

Quality Inspection:

• In the laboratories of our factory according to the specification. and
• ISO 9001-2015

For the attention of the user:

This technical specification is for  non-binding general information  only. The product is a professional product for professionals only who have already acquired previous experience in its application. What is written in this specification is not intended to be used as a substitute for advice/guidance by an authorized consultant/instructor . It must first be applied to a small area to check suitability before applying to large areas. The content of this specification changes over time and updates are made to it, the manufacturer has the right to change it at any time without prior notice. Request current versions. Names of professional advisors/instructors can be obtained by phone. The MSDS safety instructions of the product must be read  before starting to work with it. And

Manufactured by Denber Paints and Coatings Israel Ltd. , P.O. Box 690 Sderot, 80100, certified by the Israeli Standards Institute in accordance with the  ISO 9001-2015 standard