Carbo Flash carburetor cleaner
Removes burnt carbon and oil from carburetors,

Carbo Flash carburator cleaner www.denber-paints.co.il
High performance active fluid to remove/clean, by immersion, hard burnt carbon & oil from carburetors, Suitable for cleaning parts made of aluminum. Contains special surface active detergent as well as solvents, to penetrate through the burnt carbon & oil layers, in order to soften and dissolve it. The product is suitable only for professionals to use with proper ventilation! (Due to the toxic fumes). The product is dangerous for the human skin and eyes, avoid any contact with bare hands.
Carbo Flash carburetor cleaner
Removes burnt carbon and oil from carburetors,
Properties:
- Excellent burnt carbon & oil remover, dissolve thick and hard layers.
- The product cleans efficiently quickly, leaving a very clean surface.
- Suitable to clean, by immersion carburetors made of aluminum.
- The product has an excellent dissolving power; it is suitable and easy for application in garages & industry.
- The product is economical, suitable for many cleaning cycles.
Applications:
- Suitable to clean used carburetors by immersion.
Technical data:
- Immersion time – 20-30 minutes.
- Density – 1.1-1.2 gm/cm3
- Viscosity – 13 sec, #4
- Acidity – 11-13 ph
Contains:
- Surface active materials.
- Solvents.
- Detergents.
- Additives.
Carbo Flash carburetor cleaner
Removes burnt carbon and oil from carburetors,
Color:
- Yellowish.
Application methods:
- Immersion.
Dilution:
- Not for dilution.
Directions for use:
- Immerse parts for cleaning with appropriate secure equipment to avoid spillage.
- Lowering for dipping must be very slowly and carefully to avoid spillage out of the iron bath where the carbo flash cleaner should be stored with an hermetic lid that can be locked to prevent contact with non-authorized persons.
- After 30 minutes or more if needed, take the parts of the carbo flash cleaner and wash carefully with water and after it with high pressure water.
Package:
- 5 liter, 18 liter.
Storage:
- In well shaded place in room temp. with appropriate ventilation. Far from people to avoid breathe its vapors and prevent from touch it.
- Keep lid always close.
Shelf life:
- 12 months in origin package.
Carbo Flash carburetor cleaner
Removes burnt carbon and oil from carburetors,
Tools cleaning:
- After empty the bath from the used dirty material, wash with water and disposal the sediments.
Quality control:
- In factory laboratories according to specifications.
- COA and COC certificate.
- ISO 9001-2015
Safety precautions:
- Poison, Inedible, not for any contact with any part of the body, keep away from the reach of children. Cause in contact hard burns and skin peeling. In contact with eyes can cause permanent blindness.
- Not flammable but long contact with aluminum can emit hydrogen that is why forbidden to smoke near it.
- While using, good air ventilation is important. In case there is not enough air, use external
- Wear protective face mask, high quality strong gloves for chemicals and pvc protective suit to cover the body.
- Avoid direct contact of the carbon cleaner with the eyes and skin. In case of contact, immediately wash thoroughly with water.
- Avoid breathing the vapors of the material. Can cause internal damage to the body.
- In case of an injury immediately get doctors assistance. Treat contact as burns treat
- Read the safety instructions on the labels.
- See M.S.D.S
Carbo Flash carburetor cleaner
Removes burnt carbon and oil from carburetors,
Warnings:
- Don’t mix the product with materials which were not recommended by us.
- Don’t use it if the temperature is under +7°C.
- Read thoroughly the technical data of the product listed in this section; confirm that everything is understood completely, for clarification contacts our tech. department.
- All information that is listed in this content is a recommendation merely and cannot be applied in the court of law.
- The costumer must test & check that this product is compatible with his equipment and needs.
- The information listed in this section is according to the laboratory conditions (temperature, humidity etc.) which the products were tested.
- The recommendations listed do not hold any responsibility for this product.
- The information listed in this section is based on experience and accumulating data, Denber inc., has the right to change the information listed at any time.
- Products that have been in stagnation or exposed to air more than needed could have their qualities changed.
Clarifications:
- Storage room temperature 15°C to 25°C .
Quality inspection:
-
- Prior to the using on large surfaces it is important to test the product on a small area, to be sure that the paint is compatible with the level of satisfactory.
- Laboratory testing was made according to the standards institution specifications.
- This “Data sheet” given as an noncommittal information, the product above recommended for professional painting specialists. This information is not a substitute to personal guidance.
- You must read the MSDS safety instructions before you start working with the product.
Carbo Flash carburetor cleaner
Removes burnt carbon and oil from carburetors,
- For more information about Denber Paints and Denber Projects, please contact us by phone and/or to the company’s websites:
- company profile English also
- For more details please refer to the Denber website also
- For our Facebook page click here also
- To the Facebook page of the CEO of Denber also
- For more projects click here also
- To the article: Sealer for stone and concrete and marble also
- To the article: Thermal insulation in nanotechnology also
- article: Thermal insulation Thermosil 200 energy saving in green construction also
- Related article: Thermal insulation, floor coating also
- To the article: Thermal insulation in nanotechnology company Denber also
- Fire resistance of houses, hardwood and parquet floors, decks also
- Swelling paints for steel protection against fire – Fire retardant paint also
- Epoxy floor coating in casting and painting also
- Crystal epoxy resin for tables also
- To the article Sealing also
- The complete article on the sealing materials for roofs and walls also
- Sealing the floor of the balcony, terrace from rain also
- Mold, how to remove mold correctly and how to fight mold also
- “Sick” buildings – Antibacterial paints Bacterinoll/ Tutgum Bacterinol also
- Paint for aircraft Denbergloss Jets also
- Asphaltflex execution specification – Denber Paints also
- Denbergloss grainy car paint also
- Denbergloss Clear also
- Varnish for wood. How to choose the right varnish for wood also
- Crystal epoxy for tables from Denber also
- Paint for swimming pools, epoxy Epoxyden Dengal, performance specification also
- Color specification of quadrant helmets also
- For a free consultation, call Denber – Dr. Blen Evgenia – 050-3551549 / 050-3551551 also
- Need advice? Contact us by email: Denber@bezeqint.net or contact us at 08-9960794