IPA isopropyl alcohol

Electronic Cleaning Solvent

Cleaning printed circuits after finishing soldering to remove flex. Dissolves solder pastes and cleans the board and solder points and

See also in the spray –  Solvent cleaning spray for electronics

Alcoholic liquid for electronics to clean printed circuits from solder flex and dirt.

Characteristics:

• Flex solder paste remover.
• Removes grease and dirt.
• For application by application/spraying/immersion.
• Evaporates quickly from the surface and leaves a clean area.

uses:

• For cleaning printed circuits and electronic parts.
• To remove dirt and grease.

Technical data:

• Density – 0.785 gm/cm ³
• Viscosity – 10-15 seconds #2

 containing:

• isopropyl alcohol.

Electronic Cleaning Solvent

variety:

• Clear.

packing:

• 1 liter, 5 liters, 18 liters, 200 liters.

storage:

• In a cool and shady place at room temperature with adequate ventilation.
• Make sure that the immersion bath lid is tightly closed to prevent rapid evaporation of the material in the bath.

Shelf Life:

• 12 months in the original packaging.

safety:

• Not for food, keep out of reach of children.
• Flammable, away from sources of heat, sparks and fire.
• Ensure adequate ventilation during application.
• Wear safety glasses, solvent-resistant gloves, protective clothing.
• In case of injury – seek medical attention immediately.

warning:

• Do not mix with materials not recommended by us.
• Avoiding contact with the skin and eyes, causes dryness and irritation of the skin. In case of contact, wash with plenty of running water and seek medical attention.

Quality Inspection:

• In the laboratories of our factory according to the specification.
• ISO 9001-2015

For the attention of the user:

This technical specification is for  non-binding general information  only. The product is a professional product for professionals only who have already acquired previous experience in its application. Nothing written in this specification is used as a substitute for advice/training by a consultant/authorized guide . It must first be applied to a small area to check suitability before applying to large areas. The content of this specification changes over time and updates are introduced, current versions must be requested. Names of professional consultants/instructors You can get by phone. You must read the  MSDS safety instructions  of the product before starting to work with it.

Manufactured by Denber Paints and Coatings Israel Ltd., PO Box 690 Sderot, 80100, certified by the Israeli Standards Institute in accordance with the  ISO 9001-2015 standard