Epoxyden floor antistatic colors 100% for casting

Antistatic epoxy coating resistant to hard abrasion for floors  in one thick casting, also available in a thin layer Bolero roller, two-component, hard top, 100% solids, leveling, special for coating floors in casting, in shades, for electronics laboratories and test and control rooms with sensitive and precise electronic equipment, clean rooms , rooms with precise measuring equipment, battery rooms and others, for resistance to particularly difficult conditions including resistance to chemicals and severe abrasion, also for driving forklifts, especially suitable as a smooth monolithic top coating for floors to prevent static electricity. Very smooth but does not slip, repels dust, in many shades.

EPOXYDEN FLOOR  ANTI-STATIC – Anti-static floor coating by pouring  high build layer, 100% solids, self leveling, in colors.

Antistatic epoxy for casting floors Antistatic fluor epoxy in shades for casting

Characteristics:

• High-quality electrical conduction, which brings static electricity to copper strips that are below and connected to grounding. Conducts electricity well and works even without the copper strips.
• Very thick and powerful. Resistant to blows, scratches and large loads. With a thickness of 3 mm it is suitable for a floor on which heavy logistic tools move, with a thickness of 1 mm it is suitable for pedestrians and medium loads of lift trucks up to 1 ton.
• Levels itself. Creates a smooth and hard surface – monolithic without seams, beautiful to look at and easy to clean.
• 100% solids – no evaporation of solvents (thinners) and bad odors and can be applied in minimal ventilation conditions.
• Resistant to acids and alkalis according to the attached table.
• Resistant to standing water and also to those mixed with industrial and chemical waste for a long time.
• and resistant to fuels and oils. Resistant to detergents and industrial chemicals. UV resistant
• and resistant to blows, scratches and heavy loads.
• Very washable and repels dust and dirt.
• Excellent adhesion to any hard infrastructure and especially to the Epoxy Fluor Antistatic Primer base layer.
• It is easy to apply in casting as it has self-leveling ability.
• Heat and cold resistance. Resistant up to   200 ^° C for short periods and 100 ^° C heat  for a long time.
• High or low shine in a thin layer with a bolero roller.
• Crack in the floor – can be repaired very easily and at a very low cost.

Casting antistatic epoxy floors 10 ⁴ -10 ⁸  Ohm

uses:

• Coating floors and roller shutters and work surfaces in control rooms, clean rooms, electronics factories and laboratories – to prevent the effect of static electricity on sensitive electronic equipment.
• For coating floors in battery rooms.
• Coating floors and work surfaces in factories and warehouses of weapons and ammunition to prevent explosions .
• and coating floors in factories and warehouses containing cartons, paper, thinners and flammable materials to prevent ignition.
• For static electricity control in production halls and others

Technical data:

• Consumption – 1 liter per 1 square meter with a thickness of 1 mm, 3 liters per square meter with a thickness of 3 mm.
• Recommended layer thickness – 1-5 mm according to load resistance needs.
• Density – 1.3-1.7 gm/cm ³
• Base to hard ratio – 4:1 by volume.
• % solids – 100%.

packing:

• 4+1 = 5 liters. 14.4+3.6 = 18 liters

For the attention of the user:

This technical specification is for non-binding general information only. and

Manufactured by Denver Paints and Coatings Israel Ltd. , P.O. Box 690 Sderot, 80100, certified by the Israeli Standards Institute in accordance with the  ISO 9001-2015 standard

For the full specification:  antistatic epoxy for casting floors