Polyurethane tile gaps filler

Polyurethane tile gaps filler

Flexible polyurethane rubber paste for sealing professional tile gaps

Professional two-component, 100% solid grout for gaps exposed to the sun, in ceramic tiles in swimming pools, ceramic gaps in sun terraces, for use in natural and artificial stone exterior wall coverings, in aluminum wall covering connections, flexible and sealing and bridging cracks, for durability for many years.

Characteristics:

• Flexible extends by 250% and bridges capillary cracks in gaps created by ground movements.
• A perfect sealer from water, repels rain and moisture and prevents them from entering the pores/powerhouses.
• Very strong. Fills gaps and seals.
• Resistant under water and suitable as a quarter for ceramic fumes in swimming pools, hot tubs, etc.
• Excellent adhesion to galvanized iron and concrete infrastructure.
• The strength of its adhesion allows a thick coating with a thick application without a thickness limit.
• Significantly and immediately stops water penetration.
• Easy to apply and dries quickly.
• Flexible and absorbs shocks and mechanical blows.
• Resistant to marine environment and sea water. Resistant to various chemical solutions and solvents and solvents
• Does not contain volatile solvents – a particularly economical coating 100% solids.
• When exposed to the sun, it must be covered with an acrylic Danbergloss within a few hours. Swimming pools in the sun should be treated with epoxy dangle. 

Uses:

• Gun for filling ceramic voids in swimming pools
• Gun for filling voids in sun terrace tiles exposed to rain..
• And a gun for filling in hard exterior coverings such as natural and artificial stone, marble.

Flexible polyurethane rubber paste for sealing professional gaps

Technical data:

• Flexibility – 1 mm (sheen)
• Elongation – 250%
• Adhesion – above the strength of the concrete.
• PULL OF TEST – 800psi
• Heat resistance – up to 120 degrees in constant heat, up to 160 degrees thermal market.
• Density – 1.2-1.3 gm/cm ³
• Viscosity – 20,000 cps (Brookfield).
• Stiffness – 3 >Dg (Ericsson).
• Mixing ratio – 3:1
• Abrasion – 120 micron – 3500 cycles (Gardner) ASTM.
• Recommended layer thickness – no thickness limit and as needed.
• % solids by volume – 100%
• Pot Life – for a mixture of 5 liters at a temperature of 20 degrees – one hour. At 35 degrees – 30 minutes.
• Pot Life with 15% dilution in D11 thinner at a temperature of 20 degrees – two hours.

containing:

• Special polyol 100% solids and
• keys. and
• Melanins, pigments. and
• additives. and

Flexible polyurethane rubber paste for sealing professional gaps

Color:

• Cloudy transparent to mix with sand to get a natural shade for natural stone, red/brown, gray, and any other shade by order and

Gloss:

• silk. and

Touch drying :

• 6 hours, final – 24 hours, final difficulty – 7 days

Drying between layers:

• 6-24 hours depending on the ambient temperature. fingerprint test.f

Preparing the concrete and steel area:

• Thorough cleaning of dust, grease, dirt and loose paint. Ambient temperature 10-30 degrees. The surface temperature must be at least 3 degrees above the dew point at the time of application. For cracks in concrete – the strength of the concrete is at least 35. The concrete is at least 28 days old (after full curing) and
• Light polishing and thorough vacuuming must be done, primer 450 for moist areas and epoxy fluor universal transparent primer for all areas of voids/concrete or concrete, and

See also  polyflex 225 flexible 250% polyurethane rubber for concrete and metal