Asphalt repair 15

Asphalt repair 15

Fast bituminous for repairing potholes and cracks in roads

A powerful special mixture, easy to compact (can be compacted without compaction), quick drying, of aggregates and bitumens and emulsifiers, for filling holes and depressions and grooves in asphalt roads, for quick and efficient repair without the need for massive heating and compaction. For application with simple, easy and fast means without the need to shut down traffic on the road for an extended period of time, for immediate use after filling the pit.

Very thick and powerful, for flexible filling and sealing of cracks and pits in asphalt areas, for resistance to high pressures and severe vibrations. For abrasion and compression resistance of all types of vehicles under all loads. Suitable for all types of wheels with and without air. Resistant to deep freezing temperatures and unlimited thawing. Suitable for driving vehicles and forklifts .

COLD ASPHALT – FAST DRYING EMULSION BITUMEN ASPHALT FOR QUICK FIXING HOLES ON THE ASPHALT ROADS FOR IMMEDIATE USE.

Asphalt repair 15 www.denber-paints.co.il

Characteristics:

Dries quickly, there is no need to close roads for a long time for the repairs.
Flexible, very strong, abrasion resistant.
It is easy to tighten from the vehicle wheels, no road clamp is needed.
Seals water, repels moisture and prevents its penetration.
Fills holes and cracks perfectly.
Excellent adhesion to existing asphalt infrastructure.
Easy to apply and dries quickly.
Resistant to the wear of light, heavy car wheels and forklifts.
Resistant to heat exposure to hot sun and resistant to snow and freezing.
Flexible and shock absorber and hard and violent mechanical blows and suitable as a shock and noise absorber.
For casting of any required thickness at once.

Fast bituminous for repairing potholes and cracks in roads

Uses:

Repairing potholes in asphalt roads.
Repairing large cracks in asphalt roads.

Technical data:

Theoretical coverage – a 20 kg bag to repair asphalt with a thickness of 10 cm for an area approximately 33×33 cm.
Elongation of the emulsion – 600% <
Stiffness – < 10 Dg (Ericsson).
Adhesion capacity – 120 kg/cm2.
Maximum resistance to vertical load per square meter – 40 tons.
Abrasion – 10 cm – 5600 cycles (Gardner) ASTM wheel CS-17, kg load, 1000 cycles, loss > 20 milligrams according to the ASTM4060 standard
Recommended layer thickness – no thickness limit but not less than 2 cm.
Recommended number of layers – one thick layer or unlimited additional layers in the future.
Minimum ripening time for use – immediately.
Final ripening time – 3-7 days.

Touch drying :