Denbergloss gray aviation antistatic

Denbergloss gray aviation antistatic

Two-component polyurethane antistatic paint, wear-resistant, discharges static electricity

Denbergloss gray aviation antistatic www.denber-paints.co.il

Characteristics:

A high-quality electrical conductor that causes an antistatic electrical discharge that is created during movement and friction.
Excellent adhesion to aviation aluminum parts, plastic, PVC, and most infrastructures.
Resistant to outdoor conditions.
Resistant to severe abrasion at high speed of dust, sand, rain, hail, etc.
and resistant to UV radiation
Highly flexible paint.
High hardness and resistance to mechanical blows and scratches.
Low electrical resistance, high conductivity for abnormal, high and low electrical currents.
Two-component, for professional use.
Resistant to high inrush currents such as lightning as well as differences in the intensity of electric currents.
A minimum layer thickness of 50 microns is required to obtain quality conduction of 0.01-100 kilo ohms.

Uses:

Painting airplane and helicopter blades.
Exterior and interior painting of electronic equipment and plastic cases for all types of electronic/electrical equipment.
For grounding sensitive electronic equipment.
For grounding lightning or voltage intrusions.
To shield electrical and RF cables.

Technical data:

Theoretical coverage – 1 liter per 10 square meters (wet layer 100 microns).
Flexibility – 1 mm (sheen)
Density – 1.3-1.6 gm/cm ³
Viscosity – 2-3 sec (HAAKE)
Stiffness – 10 Dg (Ericsson)
Hardness – 84 Shore A
Recommended layer thickness – 40-50 dry microns.
The amount of conductive materials: 25-50%
Amount of solids – 50-70%
Adhesion – B5 (3359-78 ASTM D-)
Resistance – a strip 10 cm long and 1 cm wide and 100 microns thick dry – 1-3 kilo ohms
Recommended number of layers – at least 5, to obtain a dry thickness of 200 microns and more for abrasion resistance of the aircraft blades in outdoor conditions.

Color:

Gloss:

Dilution:

In thinner D-11 up to 35% by volume to obtain a thinness suitable for uniform spraying without leaks.
Airless – thinning up to 10% nozzle 0.015″

Area preparation:

Thorough cleaning of dust, grease, dirt and loose paint.
It is recommended to go over the surface with a cloth dipped in thinner or high-quality alcohol to ensure an area free of grease. For heavy greasy dirt, use degreaser M for high-quality degreasing.
Rubbing with glass wool to remove grains and blowing with air pressure if the surface is particularly bad for example faded is used.

Primary color:

Usually there is no need, if there is no adhesion of the paint to the infrastructure, the factory should be consulted about a suitable foundation or preparation of an unusual area.
For exposed aluminum – repairable aviation foundation. Dunbargloss jet primer, chromate-free or strontium chromate white aviation primer epoxy.

Packing:

Storage:

Shelf Life:

Cleaning tools:

Safety:

Not for food, keep out of reach of children. and
Flammable, away from heat and fire. and
Ensure adequate ventilation during application. and
Wear goggles, gloves, protective clothing. and
In case of injury – wash with plenty of running water for about 10 minutes and seek medical attention immediately. and

This technical specification is for non-binding general information only. and

Manufactured by Denber Paints and Coatings Israel Ltd. , P.O. Box 690 Sderot, and